My design is quite a simple but delicate. It is basically two rings on top of each other. At first, I wanted my design to be wavy but I couldn’t figure how to do that. However, in the process, I made the design I decided to with. I like minimalist designs so it spoke to me.
I try to print on the ultramaker a couple time but it was so small that I wasn’t looking like anything. I decided to make it a little bigger and then you can see the design a little more.
In meshmaker, I try to add strips to the bottom section. Unfortunately, because the ring is so small I couldn’t get it to work.
I ended up ordering in Yellow Strong and Flexible material with no meshmaker design on it. This is how it turned out printed through Shapeways:
You can buy this ring in style on SHAPEWAYS.