3D Project Seminar

3D Project Seminar

Pushing the Boundaries of 3D Printing

Skip to content
  • About This Seminar
  • Student Posts

October 2016

There was one post published in October 2016.

An introduction to my 3D printing project: Zoetropes and homotopies

Our project will use 3D printing to create a series of models demonstrating homotopies, or continuous deformations, between two objects. These can sometimes be hard to visualize. The classic example is of the donut and the coffee mug. These are homotopy equivalent, that is, there exists a continuous deformation from one into the other.

by Jonathan Gerhard October 17, 2016 | Comment

Spring 2017 Students

  • Xiang Chen
  • Jonathan Gerhard
  • Adam Slattum

Archives

  • April 2017
  • March 2017
  • February 2017
  • January 2017
  • November 2016
  • October 2016

Meta

  • Log in
  • Entries RSS
  • Comments RSS
  • WordPress.org
Independent Publisher empowered by WordPress